SFT PRO

SFT PRO is a new generation of Cardan joint drivelines designed to satisfy the demanding needs of machine manufacturers and professional operators.

Greater efficiency and excellent performance are assured by long life, reduced maintenance, and ease of use. These are the strengths of this extraordinary drive shaft.

LONGER LIFE

The SFT PRO drive shaft has been designed to last for over 2000 operating hours on professional agricultural equipment. The performance of the SFT PRO is far superior to any driveshaft of comparable size that we have tested under equal operating conditions.

INNOVATIVE JOINTS

SFT PRO Cardan joints are extremely rigid and compact thanks to new geometries of yokes and cross kits.

CROSS KIT PRO ©

The revolutionary Cardan joint cross kits used on SFT PRO drive shafts are permanently lubricated.

Needle roller bearings are produced, assembled, and lubricated in our factories. They need no additional grease for their entire working life. An extraordinary result of Bondioli & Pavesi technology.

LESS MAINTENANCE

Cardan joint cross kits on SFT PRO are permanently lubricated
Telescoping member lubrication interval extended to 250 hours
Safety guard bearing lubrication interval extended to 250 hours
All grease fittings aligned, quickly located, and easily accessible

REDUCTION OF TELESCOPING FORCES

Lower axial thrust forces thanks to new tube geometry

Thanks to the new Greasing System Pro, only one grease fitting is required to lubricate all contact surfaces of the telescoping tubes - at any drive shaft operating length.

An innovative guard system far superior to current safety standards and regulations.

The guard tubes are designed to telescope easily in aggressive environments.

Manufactured in Bondioli & Pavesi factories. All SFT PRO drive shafts are equipped with this sturdy guard system that allows the use of a single restraint chain.

ENVIRONMENTAL PROTECTION

Higher efficiency, longer life and lower grease requirements help protect the environment.